Gas extinguishing systems for wind
turbines:
VentusSafe - the innovative extinguishing system for wind
turbinesDescribtionGermany
takes a leading position in the world in wind power. With the
extinguishing system VentusSafe by KIDD-DEUGRA the large plants gets
even safer.
Catalysts
for fires in wind turbines can be: Lightning,
overheated hydrocarbons such as mineral oils, greases and synthetic
oil, used in gearboxes, transformers and couplers,
Electrical
fires in cabinets, distributors, generators, rectifiers and air
conditioning components.
In Germany are currently
nearly 14,000 wind turbines installed, more than in any other
country in the world. These facilities currently produce about
12,000 megawatts of power per year, which corresponds to a share of
around 2.6 percent on the German net electricity consumption. After
a reference of the federal government, 12.5 percent of electricity
requirements should be made from renewable energy sources until the
year 2010 (whose share is currently at eight percent). But the large
rotor systems are vulnerable to damage, which in turn deter the
insurance companies and the insurance is expensive.

Only
in the last year the damage of wind turbines causes a average of
approximately 40 million euros. Especially fires are dangerous for
the up to 100 meters high towers. In these heights is a deletion of
the fire by the fire brigade impossible. Especially the engine house
(gondola) suits high demands to an extinguishing system. During
operation vibrations, fluctuations and dust formation by the
abrasion of the brake device are generated. Due to the poor
accessibility at high altitude is an automatic and
maintenance-friendly system required. The fighting system VentusSafe
now offers the optimal solution for the difficult conditions.
The VentusSafe-extinguishing system for wind power has two
components: the fine spraying extinguishing system for liquid fires
and the gas extinguishing system for electric fires in closed
institutions.
The VentusSafe energy system operates
independently and is nearly maintenance free. Maintenance work is
mainly limited to visual inspections.
The fine
spraying extinguishing technic

The
good effect of fine spraying extinguishing systems based primarily
on the high heat of vaporization of the water, supplied by the large
surface of fine droplets:
Special nozzles produce a fine water
mist.
The
cooling effect of fire leads to disruption of the thermal reaction.
Through the simultaneous cooling of the environment, solid or liquid
substances are no longer ignite. Beside the cooling effect with the
fine spraying extinguishing systems also an embroidery effect is
achieved.
The VentusSafe system operates with a
high-extinguishing fluid which is specially designed for the
fighting of such kind of fires. In addition to the above-mentioned
advantages of the fine spraying extinguishing technic, a thin,
extremely slip aqueous film and a thick barrier layer, which
reliably against a restraint protects ignition will be educted by
the wet extinguishing system. The wet extinguishing system is
controlled by an patented automatically trigger pulsed element.
Increases the temperature above 79 ° C, a fast sprinkler opens and
provides a pneumatic pulse, with which the extinguishing valve of
the tank is opened. Optionally the system can be activated manually,
remote electric (12V or
24V) by pressing a print button .
The
gas extinguishing technicThe extinguishing effect of
gases is based on the oxygen displacement, which generates a
suffocation effect. For closed electrical hazards, the extinguishing
of CO2 gas is used. The extinguishing agent will also be released by
a sprinkler element , which opens after crossing the required
temperature the cylinder. The release temperatur VdS is in
accordance with the guidelines at 30 ° C above the maximum expected
temperature in the defined scope.